User's Manual Part 2

CLI for Mesh and Access Point Module MeshMAX 5054 Series User Guide
User Guide
296
DNS Client for RADIUS Name Resolution
DHCP Server Parameters
* The DHCP Server (dhcpstatus) can only be enabled after a DHCP IP Pool table entry has been created.
DHCP Server table for IP pools
* IP addresses must be from within the same subnet as the AP.
† Set End IP Address or Width, but not both.
Name Type Value Access CLI Parameter
DNS Client Group N/A R dns
DNS Client status Integer enable
disable (default)
RW dnsstatus
Primary DNS Server IP
Address
IpAddress User Defined RW dnspridnsipaddr
Secondary DNS Server
IP Address
IpAddress User Defined RW dnssecdnsipaddr
Default Domain Name Integer32 User Defined (up to 254
characters)
RW dnsdomainname
Name Type Value Access CLI Parameter
DHCP Server Group N/A R dhcp
DHCP Server Status* Integer enable (1) (default)
disable (2)
delete (3)
RW dhcpstatus
Gateway IP Address IpAddress User Defined RW dhcpgw
Primary DNS IP Address IpAddress User Defined RW dhcppridnsipaddr
Secondary DNS IP
Address
IpAddress User Defined RW dhcpsecdnsipaddr
Number of IP Pool Table
Entries
Integer32 N/A R dhcpippooltblent
Name Type Value Access CLI Parameter
DHCP Server IP Address
Pool Table
Table N/A R dhcpippooltbl
Table Index Integer User Defined N/A index
Start IP Address* IpAddress User Defined RW startipaddr
End IP Address*
†
IpAddress User Defined RW endipaddr
Width
†
Integer User Defined RW width
Default Lease Time
(optional)
Integer32 3600 - 86400 sec
(default)
RW defleasetm
Maximum Lease Time
(optional)
Integer32 3600 - 86400 sec
(default)
RW maxleasetm
Comment (optional) DisplayString User Defined RW cmt
Status (optional) Integer enable (1)
disable (2)
delete (3)
RW status