User's Manual Part 2

Configuration MeshMAX 5054 Series User Guide
Advanced Configuration of Mesh and Access Point Module
177
2. Set the VLAN Management ID to a value of between 1 and 4094. (A value of -1 disables VLAN Tagging).
3. Place a check mark in the Enable VLAN Tagging box.
Provide Access to a Wireless Host in the Same Workgroup
The VLAN feature can allow wireless clients to manage the AP. If the VLAN Management ID matches a VLAN User ID,
then those wireless clients who are members of that VLAN will have AP management access.
CAUTION: Once a VLAN Management ID is configured and is equivalent to one of the VLAN User IDs on the AP, all
members of that User VLAN will have management access to the AP. Be careful to restrict VLAN
membership to those with legitimate access to the AP.
NOTE: When VLAN is enabled, ensure that all devices in the network share the same VLAN ID.
1. Click Configure > SSID/VLAN/Security > Mgmt VLAN.
2. Set the VLAN Management ID to use the same VLAN ID as one of the configured SSIDs.
3. Place a check mark in the Enable VLAN Tagging box.
Disable VLAN Tagging
1. Click Configure > SSID/VLAN/Security > Mgmt VLAN.
2. Remove the check mark from the Enable VLAN Tagging box (to disable all VLAN functionality) or set the VLAN
Management ID to -1 (to disable VLAN Tagging only).
NOTE: If you disable VLAN Tagging, you will be unable to configure security per SSID.
Security Profile
See the following sections:
• Security Features
• Authentication Protocol Hierarchy
• VLANs and Security Profiles
• Configuring Security Profiles
Security Features
The AP supports the following security features:
• WEP Encryption: The original encryption technique specified by the IEEE 802.11 standard.
• 802.1x Authentication: An IEEE standard for client authentication.
• Wi-Fi Protected Access (WPA/802.11i [WPA2]): A new standard that provides improved encryption security over WEP.
NOTE: The AP does not support shared key 802.11 MAC level authentication. Clients with this MAC level feature must
disable it.
WEP Encryption
The IEEE 802.11 standards specify an optional encryption feature, known as Wired Equivalent Privacy or WEP, that is
designed to provide a wireless LAN with a security level equal to what is found on a wired Ethernet network. WEP
encrypts the data portion of each packet exchanged on an 802.11 network using an Encryption Key (also known as a
WEP Key).
When Encryption is enabled, two 802.11 devices must have the same Encryption Keys and both devices must be
configured to use Encryption in order to communicate. If one device is configured to use Encryption but a second device
is not, then the two devices will not communicate, even if both devices have the same Encryption Keys.