User's Manual Part 2

Monitoring MeshMAX 5054 Series User Guide
Monitoring Options for Mesh and Access Point Module
199
Figure 7-1 Monitor Main Screen
2. Click the tab that corresponds to the statistics you want to review. For example, click Learn Table to see the list of
nodes that the AP has discovered on the network.
3. If necessary, click the Refresh button to update the statistics.
Each Monitor tab is described in the remainder of this chapter.
Version
From the HTTP interface, click the Monitor button and select the Version tab. The list displayed provides you with
information that may be pertinent when calling Technical Support. With this information, your Technical Support
representative can verify compatibility issues and make sure the latest software are loaded. This screen displays the
following information for each Access Point component:
• Serial Number: The component’s serial number, if applicable.
• Name/ID: The AP identifies a system component based on its name or ID. Each component has a unique identifier.
• Variant: Several variants may exist of the same component (for example, a hardware component may have two
variants, one with more memory than the other).
• Version: Specifies the component’s version or build number. The Software Image version is the most useful
information on this screen for the typical end user.