User's Manual Part 2

Procedures for Subscriber Module MeshMAX 5054 Series User Guide
223
2. Access the Subscriber unit as described in Logging in to the Web Interface.
3. Click the Commands button and the Download tab.
4. Fill in the following details:
• Server IP Address <IP address TFTP server>
• File Name <image file name>
• File Type Image
• File Operation Download
5. Click OK to start the file transfer.
The Subscriber unit downloads the image file. The TFTP server program should show download activity after a few
seconds. When the download is complete, the Subscriber unit is ready to start the embedded software upon reboot.
Configuration Backup
You can back up the Subscriber unit configuration by uploading the configuration file. You can use this file to restore the
configuration or to configure another Subscriber unit (see Configuration Restore).
To upload a configuration file through the Web Interface:
1. Set up the TFTP server as described in TFTP Server Setup.
2. Access the Subscriber unit as described in Logging in the Web Interface.
3. Click the Commands button and the Upload tab.
4. Fill in the following details:
• Server IP Address <IP address TFTP server>
• File Name <configuration file name>
• File Type Config
• File Operation Upload
5. Click OK to start the file transfer.
The Subscriber unit uploads the configuration file. The TFTP server program should show upload activity after a few
seconds. When the upload is complete, the configuration is backed up.
Configuration Restore
You can restore the configuration of the Subscriber unit by downloading a configuration file. The configuration file
contains the configuration information of an Subscriber unit.
To download a configuration file through the Web Interface:
1. Set up the TFTP server as described in TFTP Server Setup.
2. Access the Subscriber unit as described in Logging in Web Interface.
3. Click the Commands > Download.
4. Fill in the following details:
• Server IP Address <IP address TFTP server>
• File Name <configuration file name>
• File Type Config
• File Operation Download
• Click OK to start the file transfer.
The Subscriber unit downloads the configuration file. The TFTP server program should show download activity after a
few seconds. When the download is complete and the system rebooted, the configuration is restored.