User Manual
Table Of Contents
- Table of Contents
- Introduction
- Installation
- Wireless Topologies
- Configuration Parameters
- Harmony Utility
- Troubleshooting
- Technical Specifications
- Technical Support and Training
- Index
Troubleshooting 62
Windows ME/98 SE
Follow these steps to configure a Harmony 802.11a adapter’s networking clients and
protocols in a Windows 98/ME computer:
1. Open the Control Panel’s Network icon.
2. Select a client or protocol from the list of installed components and click
Properties to configure its settings.
For example, if you want to assign the Harmony 802.11a adapter a static IP
address, highlight TCP/IP
or TCP/IP -> Harmony 802.11a Network Adapter and
click Properties.
Note: To add a new client or protocol, click Add... and follow the on-screen
instructions.
Windows NT
Follow these steps to configure a Harmony 802.11a adapter’s networking protocols in
a Windows NT computer:
1. Open the Control Panel’s Network icon.
2. Click the Protocols tab.
3. Select a protocol from the list of installed components and click Properties to
configure its settings.
4. Select the Harmony 802.11a network adapter from the list of installed adapters.
5. Configure the protocol as necessary.
6. Click OK or Apply save your changes.
7. Close the Network screen and restart the computer if prompted.
Note: To add a new client or protocol, click Add... and follow the on-screen
instructions.