Installation guide

Tsunami MP.11 Recommended Antennas

10 dBi Omni-Directional Base Unit Antenna

General Description

The Tsunami 10 dBi Omni-Directional Base Unit Antenna is a broadband antenna for the 2.4 GHz frequency band

featuring an omni-directional pattern with a nominal gain of 10 dBi.

This antenna is typically used in combination with a Base Unit.

The pole-type antenna is enclosed in a weatherproof protective covering (“radome”). This vertically polarized

antenna can be mounted to an antenna mast with an outside diameter of up to 51 mm (2.0 in).

For detailed specifications see the table in this appendix.

DANGER! When selecting an antenna location, ensure that the general precautions are met to avoid

possible contact with electrical power lines. See the National Electrical Code for proper

grounding of the antenna mast

Mounting Instructions

1. Attach the ferrule of the antenna to the mounting bracket with two U-bolts as shown in the following figure.

2. Next use the remaining two U-bolts to attach the mounting bracket to the mast. Tighten nuts to 9 Nm (7 ft-lbs).

Mounting the 10 dBi Antenna