Installation guide

Tsunami MP.11 Recommended Antennas

Assembling the Antenna

1. Assemble the two reflector halves inserting the four #8-32 machine screws through the front. Secure with the

keps nuts on the back.

Note: Loosely tighten all hardware until completely assembled and then tighten securely.

Assemble the Reflector

2. Place the sub-reflector on the front of the feed and secure with the #6 x 1/2 inch stainless screw.

3. Determine the polarity of the antenna (see the following figure).

º Horizontal polarity, (the reflector ribs and the sub reflector at the front end of the antenna are aligned

horizontally).

º Vertical polarity: (the reflector ribs and the sub reflector at the front end of the antenna are aligned

vertically).

Determine Polarization

Polarity of the antenna must always be the same as the polarity of the antenna on the opposite side of the

link!

4. Place the ‘L’ bracket on the back of the antenna.

5. Insert two carriage bolts from the front to attach.