Specifications

Tsunami MP.11 5012-SUR Installation and Management

Configuration

This section describes configuring the 5012-SUR’s settings using the unit’s Web Interface.

Click the Configure button to access configuration settings.

The following topics are discussed in this section:

• System Parameters

• Network Parameters

• Interface Parameters

• SNMP Parameters

• RIP Parameters

• Management Parameters

• Security Parameters

• Filtering

• NAT (Routing Mode Only)

Help and Exit buttons also appear on each page of the Web interface; click the Help button to access online help; click

the Exit button to exit the application.

For an introduction to the basics of management, see Basic Management.

System Parameters

The System configuration page lets you change the 5012-SUR’s System Name, Location, and so on. These details

help you to distinguish the unit from other routers and let you know whom to contact in case you experience problems.

Click Configure> System; the following window is displayed.

In this window, you can view or change the basic system information. Mode of Operation sets the unit as bridge (layer

2) or as router (layer 3). See Bridge and Routing Modes for more information.

You can enter the following details: