Specifications

Configuration Tsunami MP.11 5012-SUR Installation and Management

Network Parameters

Enable the DHCP Relay Agent (Routing mode only)

Click Configure > Network > DHCP RA to enable the 5012-SUR DHCP Relay Agent. When enabled, the DHCP relay

agent forwards DHCP requests to the set DHCP server. There must be at least one entry in the corresponding Server IP

Address table in order to enable the DHCP Relay Agent.

Note that DHCP Relay Agent parameters are configurable only in Routing mode. It cannot be enabled when NAT or

DHCP Server is enabled.

Add Entries to the DHCP Relay Agent Table

To add entries to the table of DHCP Relay Agents, click Add Table Entries; the following window is displayed.

Enter the Server IP Address and any optional comments; click Add.

Edit/Delete Entries to the DHCP Relay Agent Table

Click Edit/Delete Table Entries to make changes; enter your changes and click OK.