Specifications

Configuration Tsunami MP.11 5012-SUR Installation and Management

Interface Parameters

• Input / Output Bandwidth Limit: These parameters limit the data traffic received on the wireless interface and

transmitted to the wireless interface, respectively. Selections are in steps of 64 Kbps from 64 Kbps to 12 Mbps.

NOTE: The aggregate maximum bandwidth shared between input and output is 12 Mbps. If you attempt to set the

input/output bandwidth values so that the total exceeds 12 Mbps, the management interface will automatically

adjust the values to the available aggregate bandwidth of 12 Mbps. For example, the system default is 6 Mbps

for both input and output bandwidths. If you change the input to 8 Mbps, the management interface will

automatically adjust the output to 4 Mbps, for an aggregate bandwidth of 12 Mbps. The values will not adjust

automatically if the total is less than 12 Mbps.

Configure the Ethernet Interface

To set the Ethernet speed, duplex mode, and input and output bandwidth limits, click Configure > Interfaces > Ethernet.

You can set the desired speed and transmission mode by clicking on Configuration. Select from these settings for the

type of Ethernet transmission:

• Half-duplex means that only one side can transmit at a time.

• Full-duplex lets both sides transmit.

• Auto-duplex selects the best transmission mode available when both sides are set to auto-select.

The recommended setting is auto-speed-auto-duplex.