User's Manual
Table Of Contents
- Contents
- 1. Introduction
- The Harmony Family
- System Requirements
- The Product Package
- 2. Installation
- Installation Procedure
- Mounting Option
- LED Indicators
- Power Requirements
- 3. Wirefree Operation
- Harmony Architecture
- The IEEE 802.11b Specification
- Roaming Between Harmony 802.11b Access Points
- Roaming Guidelines
- 4. Configuration Parameters
- Basic Settings
- AP Name
- Physical Address
- Enable AP
- Partnered APC
- Channel
- Supported Clients
- SSID
- IP Addressing
- Security Settings
- WEP Encryption
- WEP Key Size
- WEP Keys
- Advanced Settings
- Supported Rates
- RTS/CTS
- 5. Performance Hints
- Microwave Ovens
- Range
- 6. Troubleshooting
- How to Obtain Help with Your LAN Installation
- LED Error Codes
- Common Problems and Solutions
- A. Parameters
- B. IEEE 802.11b Direct Sequence Channels
- C. Harmony 802.11b Access Point Specifications
- D. How to Reach Technical Support
- Index
15
If the cells of multiple Access Points overlap, then the mobile client may switch from
one Access Point to another as it travels throughout the facility. During the hand-off
from one Access Point to another, the mobile client maintains an uninterrupted connec-
tion to the network. This is known as “roaming.”
Multiple Access Points connected to a common Ethernet network form an Extended
Service Set (ESS). All members of an Extended Service Set are configured with an ID,
known as the SSID or ESSID. Mobile clients must be configured with the same SSID
as the Access Points on the network; a client can only roam between Access Points that
share the same SSID.
Roaming Guidelines
❑ An 802.11b PC Card can only roam between 802.11b Access Points. An
802.11b PC Card cannot communicate with Harmony OpenAir Access Points.
❑ All Harmony 802.11b Access Points must have the same SSID.
❑ All workstations with Harmony 802.11b PC Cards must have the same SSID
as the Access Points that they will roam between.
❑ If WEP encryption is enabled, then all 802.11b Access Points and PC Cards
must use the same encryption level and WEP Key(s) to communicate.
❑ The Access Points’ cells must overlap to ensure that there are no gaps in
coverage and to ensure that the roaming client will always have a connection
available.
❑ All Access Points in the same vicinity should use a unique, independent
Channel. There are three independent Channels for 802.11b Access Points.
❑ Access Points that use the same Channel should be installed as far away from
each other as possible to reduce potential interference.