User's Manual
Table Of Contents
- Contents
- 1. Introduction
- The Harmony Family
- System Requirements
- The Product Package
- 2. Installation
- Installation Procedure
- Mounting Option
- LED Indicators
- Power Requirements
- 3. Wirefree Operation
- Harmony Architecture
- The IEEE 802.11b Specification
- Roaming Between Harmony 802.11b Access Points
- Roaming Guidelines
- 4. Configuration Parameters
- Basic Settings
- AP Name
- Physical Address
- Enable AP
- Partnered APC
- Channel
- Supported Clients
- SSID
- IP Addressing
- Security Settings
- WEP Encryption
- WEP Key Size
- WEP Keys
- Advanced Settings
- Supported Rates
- RTS/CTS
- 5. Performance Hints
- Microwave Ovens
- Range
- 6. Troubleshooting
- How to Obtain Help with Your LAN Installation
- LED Error Codes
- Common Problems and Solutions
- A. Parameters
- B. IEEE 802.11b Direct Sequence Channels
- C. Harmony 802.11b Access Point Specifications
- D. How to Reach Technical Support
- Index
30
A. Parameters
Parameter Name Range Default
AP Name 1-63 characters unit's physical address
Enable AP Enabled, Disabled Enabled
Partnered APC - Any
Channel
1-11; 1, 6, and 11 are
independent
Assigned by AP
Controller
Supported Clients
11 Mbps clients only,
Allow 2 Mbps clients
Allow 2 Mbps clients
SSID 1-32 characters proxim
IP Address Use DHCP, Specify IP Use DHCP
WEP Encryption
Off, Authentication, All
Traffic
Off
WEP Key Size 40 bit, 128 bit 40 bit
WEP Key(s) 10 hexadecimal digits
for 40 bit encryption,
20 hexadecimal digits
for 128 bit encryption
Blank
Supported Rates
Any combination of
11 Mbps, 5.5 Mbps,
2 Mbps, 1 Mbps
All rates supported
RTS/CTS
Always on, Always off,
Based on packet size
Always off