User's Manual
Table Of Contents
- Contents
- 1. Introduction
- The Harmony Family
- System Requirements
- The Product Package
- 2. Installation
- Installation Procedure
- Mounting Option
- LED Indicators
- Power Requirements
- 3. Wirefree Operation
- Harmony Architecture
- The IEEE 802.11b Specification
- Roaming Between Harmony 802.11b Access Points
- Roaming Guidelines
- 4. Configuration Parameters
- Basic Settings
- AP Name
- Physical Address
- Enable AP
- Partnered APC
- Channel
- Supported Clients
- SSID
- IP Addressing
- Security Settings
- WEP Encryption
- WEP Key Size
- WEP Keys
- Advanced Settings
- Supported Rates
- RTS/CTS
- 5. Performance Hints
- Microwave Ovens
- Range
- 6. Troubleshooting
- How to Obtain Help with Your LAN Installation
- LED Error Codes
- Common Problems and Solutions
- A. Parameters
- B. IEEE 802.11b Direct Sequence Channels
- C. Harmony 802.11b Access Point Specifications
- D. How to Reach Technical Support
- Index
34
Index
100Base-TX 9
10Base-T 7, 9
A
Access Point. See Harmony Access Point
Access Point Controller. See Harmony Access Point Controller
All Traffic 20, 21, 30
Antenna
Placement Considerations 25
AP AutoConfigure Defaults 13, 17
AP Name 17, 30
Authentication 20, 30
B
Basic Service Set (BSS) 14
C
Channel 14, 15, 18–19, 30, 31, 32
Clear to Send (CTS) 22
Configuration Parameters 17–23
D
DHCP 19, 30
Direct Sequence. See Spread Spectrum: Direct Sequence
Dynamic IP Addressing 20
E
Enable AP 18, 28, 30
Encryption Key. See WEP Key
ESSID. See SSID
Ethernet Cabling Restrictions 8
Ethernet LED 11
Ethernet Switch or Hub 7
Extended Service Set (ESS) 15, 21
F
FCC 2, 32
Firmware Upgrade 29