Installation guide

Chapter 3
14 Sniffer Technologies
NOTE: In most cases, the default resources found by the driver will
work. However, in some cases, you may need to identify free resources
as described in the following steps.
a
Select the Windows NT Diagnostics program from the
Administrative Tools (Common) program group under the Start
menu.
b In the dialog box that appears, click the Resources tab. The IRQs
currently in use on the PC are listed by number.
c The ORiNOCO Gold adapter card can use IRQ 3 through 12 and
15
. Determine if one of these IRQs is available and write down its
number for later use.
NOTE: If IRQ 3 through 12 and 15 are already in use, make one
available for the ORiNOCO Gold adapter by uninstalling a conflicting
device.
d
Click I/O Port at the bottom of the Windows NT Diagnostics
window. The I/O Port windows currently in use on the PC are
listed.
e The ORiNOCO Gold adapter card can use I/O base addresses
from
0180 to F000. Determine if one of these I/O base addresses
is available and write down its number for later use.
NOTE: If I/O base addresses from 0180 to F000 are already in use,
make one available for the ORiNOCO Gold adapter by uninstalling a
conflicting device.
6
Install the driver provided by Network General for the ORiNOCO Gold
adapter:
a Start the Windows Network control panel by right-clicking
Network Neighborhood and selecting Properties.
b Click the Adapters tab of the Network control panel.
c In the Adapters tab, click Add.
d Click Have Disk in the Select Network Adapter dialog box.
e In the Insert Disk dialog box, supply the path to the AgereOrinoco\
WinNT subdirectory where the driver files are installed and click
OK.