Installation guide

Wireless Guide 27
Installing the Enterasys Adapter / Driver
Enterasys RoamAbout adapter by uninstalling a conflicting device.
d
Click I/O Port.
e The I/O Port windows currently in use on the PC are listed. The
Enterasys RoamAbout adapter card can use I/O base addresses
from
0180 to F000. Determine if one of these I/O base addresses
is available and write down its number for later use.
NOTE: If the I/O base addresses are already in use, make one
available for the Enterasys RoamAbout adapter by uninstalling a
conflicting device.
7
Install the driver provided by Network General for the Enterasys
RoamAbout adapter:
a Start the Windows Network control panel by right-clicking
Network Neighborhood and selecting Properties.
b Click the Adapters tab.
c Click Add.
d The Select Network Adapter dialog box appears. Click Have Disk.
e Supply the path to the EnterasysRoamAbout\WinNT subdirectory
where the driver files are installed and click OK.
NOTE: The location for Sniffer Portable drivers is C:\Program
Files\NAI\SnifferNT\Driver\en\EnterasysRoamAbout\WinNT.
f
The Select OEM Option dialog box appears with the Sniffer
(RoamAbout) 802.11 PC Card entry highlighted. Click OK.
g Make sure the Default profile is selected, then click Edit Profile in
the Add/Edit Configuration Profile dialog box.
NOTE: Leave the adjacent drop-down field set to its default value of
Access Point (as shown in Figure 4-2).