Instruction manual

EMC Directive Requirements:
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Industry Canada:
This Class A digital apparatus meets all requirements of the Canadian Interference Causing Equipment
Regulations. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Approvals:
EMI / EMC Standards:
FCC Part 15 Subpart B
EN 50022 Class A
EN50082-1
Transceiver:
FCC Part 15, Subpart C
ETSI 300 328
IC-RSS 210
Safety Standards:
EN 60825-1
CDRH Class 2
Revision Notice
2325 Reference Guide
Upgrade from Revision A to Revision B
The revision B upgrade to this manual contains changes made to the following sections:
Section Action
Entire Manual Replace the word "terminal" with "computer."
Chapter 1 - Introduction and
Specifications
Replace "Contacting LXE" with revised text.
Chapter 2 - Using Advanced
Features
Add "Troubleshooting - Enable I 2 of 5." Add new sections: "Proxim
Configuration Settings" and "Lucent Configuration Settings."
Chapter 3 - Software
Configuration
Add section titled "Terminal Emulation."
Chapter 4 - The
Configuration Utility
Replace Figure 4-14, 4-16, and 4-18. Add new 4-19.
Chapter 7 - The Docking
Stations
Add non-rechargeable battery warning graphic and text. Add section titled
"Vehicle Mounted DC Single Dock."
Appendix B - Programming
Parameters
Remove section titled "Terminal Emulation in a 2.4GHz Radio System."
Add two new configuration parameters – Ames Enable and Spotting Beam
Enable.