Instruction manual

2-36 Radio PC Card Configuration
2325 Reference Guide Revision B 2325A137REFGD
AP_Density
Controls the roaming sensitivity of your computer. This parameter must
be set according to the settings of the Lucent access points.
Valid values: 1=Low
2=Medium
3=High
Default: 3
Transmit_Rate
Controls the data rate the Lucent card will use. Supported rates depend
on the card. If the card does not support the selected rate, the default
value of 3 is selected automatically.
Valid values: 1=Fixed Low
2=Fixed Standard
3=Auto Rate Select (High)
4=Fixed Medium
5=Fixed High
6=Auto Rate Select (Standard)
7=Auto Rate Select (Medium)
Default: 3
PortType
Defines the connection control characteristics.
Valid values: 1=Infrastructure mode (ESS) ‘normal’
network operation in environments that
include Lucent access points
3=AdHoc Demo mode
Default: 1
Medium_Reservation
Enables RTS/CTS communications. Sets the frame length threshold that
determines when the station should start using RTS/CTS.
Valid values: 0-2347
Default: 2347
Note: The use of Medium Reservation is recommended in network
environments where the density of the Lucent stations and
Lucent access points is very low, and where there is poor
network performance due to excessive frame collisions at the
Lucent access points.