Specifications

13
ADVANCED VIDEO SCALER
5. Internal DIP Switch Settings
Inside the Advanced Video Scaler are several DIP switches for installation setup
only that you do not need to access during normal operation. This section
describes how to access these switches and what they are used for.
5.1 Accessing the DIP Switches
Slide off the top cover by doing the following:
1. Remove all power and I/O connections to the unit.
2. Remove the two screws on the front panel.
3. Carefully pull off the front bezel and keypanel (which is attached to the main
circuit board by a ribbon cable), leaving the keypanel attached to the circuit
board.
4. Slide the top cover towards the front of the unit, exposing the circuit board
with the DIP switches on it.