Service manual

8
CP-SX1350(P5SX+)
VID-AD
MIN
MID-L
MID-H
MAX
DAC-P
GAMMA
C. UNIF.
No. 1 R 0
STRIPE
C.UNIF
ON/OFF ON
OFF
G0 B0
Major adjustment lattice point No.
4-7 Color uniformity adjustment
Preparations
1. Perform these adjustments after the white
balance adjustment described in Section 4-6.
2. Make a color uniformity adjustment for the
following four tones.
MIN tone (approx. 7% input signal)
MID-L tone (approx. 18% input signal)
MID-H tone (approx. 50% input signal)
MAX tone (approx. 75% input signal)
3. Place the cursor on [C.UNIF.] in the FACTORY
MENU and press the [
] key. This displays the
Adjust Tone menu at the bottom of the screen.
To choose the tone to be adjusted, press the [
] key and then use the [ ] or [ ] key.
Select the major adjustment lattice point No.
and color, and then adjust them.
4. The major adjustment lattice point numbers (a
total of 17 points) corresponds to the major
adjustment lattice point positions in the diagram
on the right. The color uniformity of the entire
screen can be adjusted by adjusting the white
balance for each of the points starting in order
from the low numbers.
5. Adjustment point No.1 should not be adjusted,
because it controls the brightness of the entire
screen.
6. To temporarily turn correction off, place the cursor
on [C.UNIF.] in the Adjust Tone menu and press
the [
] key. The ON/OFF menu appears. Place
the cursor on [ON] with the [
] key and press the [
] key. To turn it on again, place the cursor on
[OFF] and press the [
] key.
7. Although this adjustment can also be made
using internal signals, we will here use the
[ENTER] key on the Remote control transmitter
to select the following two signals.
Solid monochrome adjustment color (use G
color adjustment when a color differential
meter is used).
Solid white (use for adjustment other than
above).
8. Reset color-shading correction before
adjustment.
When 4 tones and all colors are to be reset,
place the cursor on [C.UNIF.] in the
FACTORY MENU, press the [RESET] key
and select [DEFAULT].
When only 1 tone is to be reset, place the
cursor on the tone to be reset, press the
[RESET] key and select [DEFAULT].
Single tone and monochrome resets cannot
be performed.
FACTORY MENU
Major adjustment lattice point position
14 12
13
16
15 17
6 4 8
2 1 3
7 5 9
10 11
V/6
H/6 H/3 H/3 H/6
V/3
V/3
V/6
Adjust tone menu