Datasheet

ManualsBrandsProxxon ManualsHolderHSS end mill

Complete work centre for milling and drilling:

BFW 40/E, KT 150 and BFB 2000.

Note:

The BFW 40/E is shown here as a

tool combination with the mill/drill

unit BFB 2000 and compound table

KT 150. Neither tool is included.

Mill/drill system BFW 40/E, with controller for speeds of 900 - 6,000rpm.

Slot milling

Mitre routing

Drilling co-ordinates

The triple ball bearing armature provides direct drive (no gearing). Die-cast

aluminium head with spindle neck of 43mm (European standard). Large, easy to

use switch with emergency function. Chart indicates optimum speeds for milling

and drilling of various materials.

The motor operates at 40V, supplied from the power pack/ controller. At this level,

the control characteristics are ideal and yield high torque, even at lower speeds.

(The compound table, drill stand and step clamps are not included.)

Seite

von

PROXXON

BFW 40/E

11.01.2013

http://www.proxxon.com/eng/html/20165.php

Summary of content (4 pages)

PAGE 1
PROXXON - BFW 40/E Seite 1 von 4 Complete work centre for milling and drilling: BFW 40/E, KT 150 and BFB 2000. Mill/drill system BFW 40/E, with controller for speeds of 900 - 6,000rpm. Slot milling Mitre routing Drilling co-ordinates The triple ball bearing armature provides direct drive (no gearing). Die-cast aluminium head with spindle neck of 43mm (European standard). Large, easy to use switch with emergency function. Chart indicates optimum speeds for milling and drilling of various materials.
PAGE 2
PROXXON - BFW 40/E Seite 2 von 4 Other technical data: Control unit with full wave electronics for 220 - 240V, 40VDC secondary voltage. Power consumption up to max. 250W. Spindle speed infinitely variable between 900 and 6,000rpm. Complete with triple slit, hardened collets covering 2.35 - 3.0 3.2 - 4.0 - 5.0 and 6.0mm. as well as 2 spanners. NO 20 165 http://www.proxxon.com/eng/html/20165.php 11.01.
PAGE 3
PROXXON - BFW 40/E Seite 3 von 4 Die-cast aluminium compound table KT 150. With precision milled dovetail slides, thus also suitable for metal work. For routing, milling, slotting of steel, non-ferrous metal, plastic and wood. Each slide provided with locking screws. Dovetail fittings/ gib strips adjustable to eliminate play. Feed adjustments by means of 2 handwheels with adjustable, graduated dials (one revolution = 2mm, one graduation = 0.05mm).
PAGE 4
PROXXON - BFW 40/E Seite 4 von 4 Stepped clamps, of milled steel 2 each step blocks, 2 clamps, 2 nuts and 2 T-slot nuts (B = 7mm, E = 12mm, D = 4mm, C = 7.2mm). For work pieces up to approx. 35mm thickness. In wooden box with sliding lid. NO 24 257 Precision vise, milled in steel May be used on its side and back. Jaw width of 60mm, clamping capacity 42mm. Complete with securing bolts and packed in a wooden box with sliding lid. NO 24 255 Precision V-blocks Used to clamp various work pieces.