Datasheet

43
Thicknesser DH 40
Load bearing components are all made of die-cast aluminium, with milled
seats for bearings and spindles.
These characterics are essential for vibration-free, smooth thicknessing of soft and
hard woods. Triple-spindled table (of die-cast aluminium, flat-milled) which can
be accurately adjusted to 1/10mm by handwheel (zero adjustable). Automatic
even feed with anti-kickback device: The knurled, spring-mounted infeed roller
transports even irregularly shaped work pieces. A rubber-coated outfeed roller
prevents marking the newly planed surface. Precision planer block with two HSS
planer blades.
Technical Data:
230V. 200W. 50/60Hz. Thicknessing up to 40mm thick and up to 80mm wide.
Maximum depth of cut 0.8mm. Cutter speed 6,000rpm. Feed rate 4.8m/min.
Table length 232mm. Weight approx. 8kg.
NO 27 040
Spare blades
For thicknesser DH 40. Made of HSS. Length 82mm.
NO 27 042 1 pair
Tungsten carbide tipped
Ø 80 x 1.6 x 10mm,
36 teeth.Use for balsa,
plywood, soft and
hard woods, POLY-
CARBONATE, plastics,
non-ferrous metals,
glass-fiber reinforced
circuit boards. NO 28 732
Super cut
Ø 85 x 0.5 x 10mm.
80 teeth. Use on
hard and soft
woods, plastics.
NO 28 731
Tungsten carbide tipped
Ø 80 x 1.5 x 10mm,
24 teeth.Use on
non-ferrous metals,
soft and hard
woods, laminates,
plastics
NO 28 734
Diamond coated
Ø 85 x 0.7 x 10mm.
Layer ´D100´
Ceramics,
porcelain, tiles,
stone, PC cards.
NO 28 735
For cutting wood, non-ferrous metals, plastics, Plexiglas, glass fibre reinforced sheets, foam and
many other materials. Stable construction because load bearing parts and plane-milled table are
made of die-cast aluminium.
The micro-adjustable, precise and stable longitudinal stop provides decisive advantages: Corrections
even smaller than 1/10 mm can be made after coarse adjustment using an adjusting screw. The height
adjustable and 45° tiltable saw blade makes it possible to cut double mitres when used together with
the angle stop.
Low-noise drive using DC special motor with Optibelt toothed belts. Ball-bearinged saw blade shaft.
Tungsten tipped saw blade 80 x 1.6 x 10mm (24 T). Additional work piece pusher and non-slotted ABS
sawing gap cover for tight tolerances between saw blade and table.
Technical data:
230V. 7,000rpm. Mitre infinitely adjustable up to 45°. Table size 300 x 300mm. Cutting depth 1 - 22mm.
Saw blades between 50 - 85mm can be used (with 10mm centre hole). Weight approx. 6kg.
NO 27 070
Table and drive can be lifted up and
supported like an engine bonnet. For
cleaning the device and easy saw blade
replacement.
Non-slotted sawing cap cover of ABS
for tight tolerances between saw
blade and table (is slotted from below
by the FET saw blade). For cutting
very small parts.
For fine mechanics, model building, mould construction, toy
manufacture, architects, model carpenters and fitters.
Height adjustable tungsten-tipped saw blade, tilting through 45°.