6 5 4 5 4 MI cx NIM cxc cx cx OT 40 (E) cxcx c-cxcxc MI cx NIM cxc cx cx OT 40 (E) cxcx c-cxcxc 1 1 Manual Manual 3 2 6 3 2 MICROMOT MICROMOT 50 50 (E) (E) ProxxonTools.
6 MINIM cxcx OT cxc cxc-c 40 cxcx xcxc (E) 2 6 5 4 (E) 40 xc OT xc NIM c-c MI cx cx cx cx cx c cx 5 4 1 1 3 2 -3- Fig. 3 3 Fig. 2 6 7 5 Fig.
Foreword GENERAL SAFETY RULES Dear Customer, Before putting the machine into operation, read the enclosed safety rules and operating instructions! Warning! Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. Save these instructions. This manual comprises: Foreword . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 General Safety Rules . . . . . . . . . . . . . . . . . . . . . .
Avoid accidental starting. Be sure switch is off before plugging in. Carrying tools with your finger on the switch or plugging in tools that have the switch on invites accidents. Remove adjusting keys or wrenches before turning the tool on. A wrench or a key that is left attached to a rotating part of the tool may result in personal injury. Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the tool in unexpected situations.
the other hand while in use. Allow for sufficient space between your hand and the spinning bit. Round material such as dowel rods, pipes or tubing have a tendency to roll while being cut, and may cause the bit to "bite" or jump toward you. Clamping a small workpiece allows you to use both hands to control the tool. Inspect your workpiece before cutting. When cutting irregularly shaped workpieces, plan your work so it will not slip and pinch the bit and be torn from your hand.
Description of the machine Operation Note: The set 38515 icludes additionally: 1 Power unit 1 set of tools, see page 8 1 flexible shaft, see also page 8 Clamping, changing tools Warning: Never press the locking pin (arrow Fig. 2) while the machine is running. – Turn the clamping nut 1 (Fig. 2) lightly while pressing the lock button until the pin engages. – Open the collet and change the bit. Clamp all tools as short as possible.
Accessories: WARNING! An external speed control should never be used with this tool. For complete information regarding PROXXON accessories, ask for our equipment catalog at the address provided on the last page beneath the warranty information.