User's Manual

34
VIBCONNECT RF 11.2011
5.3.4 Connecting bridge
• Feed the network cable through the left gland and the power
cable through the right gland.
• Connect the bridge to the data network and to the power
source as shown in the following diagram.
CAUTION
Risk of injury from electric shock!
When connecting the bridge to the power supply without taking
the necessary safety precautions, there is a risk of energy from
high voltage (220 V).
» The electrical connection must be established by a qualified
electrician.
» The mains voltage must conform to the IEC guidelines.
» An external interface (fuse or switch) must be provided in order
to disconnect the power supply securely.
» Before carrying out any installation, repair or maintenance work
on the bridge, disconnect it from the power supply.
Note
Risk of damage to equipment while housing is open!
Touching the electronic components on the mother board can lead
to electrostatic discharge, which can damage system components.
» If contact with such components cannot be excluded, wear an
earthing wristband.
5.3.5 Commissioning bridge
• Before commissioning the bridge, check whether all cable con-
nections and fixtures of the bridge are correctly executed.
• Switch on the power supply of the bridge.
The green LED on the power supply is on. After the operating
software has fully booted (approx. 1 minute), the bridge is ready
for operation.
Installation and commissioning