User's Manual

50
VIBCONNECT RF 11.2011
5.6 Configuration in OMNITREND (continued)
After the system components have been installed and commis-
sioned, continue configuring the system in OMNITREND (see also
“Configuration in OMNITREND”, page 27). The configuration
consists mainly of the following steps:
• Registration of bridge and sensor units
• Assignment of system components to the measuring points in
the database
• Creation of measuring configurations and loading to bridge
• Reading of measuring data from bridge
• Evaluation of measuring data in OMNITREND
Note
These instructions assume that the operator is familiar with the
OMNITREND software and its features The instructions below are
therefore kept brief.
5.6.1 Registering bridge in OMNITREND
• In the main menu, click <Options> / <Registration / Configura-
tion>.
• In the ‘Registration’ window (‘OMNITREND’ tab), check whether
‘VIBCONNECT RF’ is the current OMNITREND version. If this is
not the case, change the settings.
• Call up the ‘Measurement Device’ tab.
• Click the <Get ID> button.
• Enter the IP address of the bridge in the ‘Ethernet Setup’
window (see also “Changing IP address or bridge”, page 30).
If required, adjust the Subnet Mask and the Gateway address.
Click the <OK> button.
• Enter the name of the bridge in the ‘Configuration’ window
and click the <OK> button. OMNITREND establishes a connec-
tion to the bridge, reads its serial number and indicates it in the
‘ID’ field.
Installation and commissioning