Installation and Operation Guide
Table Of Contents
- Chapter 1: Introduction
- 1.1 First steps
- 1.2 Service addresses
- 1.3 About this manual
- Chapter 2: Safety
- 2.1 Safety symbols
- 2.2 Information for the system operator
- 2.3 Information for operating personnel
- 2.4 Intended use
- 2.5 Residual risks and safety measures
- Declaration of conformity
- Certifications
- Chapter 3: Technical data
- Chapter 4: System description
- 4.1 VIBCONNECT RF bridge
- 4.2 VIBCONNECT RF sensor unit
- 4.3 VIBCONNECT RF sensor
- Chapter 5: Installation & commissioning
- 5.1 Quick guide
- 5.2 Configuration in OMNITREND
- 5.3 Installation & commissioning of bridge
- 5.4 Installation & commissioning of sensor unit
- 5.5 Installation of sensors
- 5.6 Configuration in OMNITREND (continued)
- 5.7 Installing additional sensor unit
- Chapter 6: Maintenance
- 6.1 Cleaning
- 6.2 System time correction
- 6.3 Installation report
- 6.4 Battery-powered sensor unit
- 6.5 Update
- 6.6 Warranty
- 6.7 Spare parts and accessories
- Chapter 7: Troubleshooting
- Chapter 8: After use
33
VIBCONNECT RF 05.2012
• Click <Network Settings> and enter the new IP address for the
bridge. If required, change the address of the Subnet Mask and
Gateway, and then click the <Save Settings> button.
Note
Note down the new IP address of the bridge as it might be needed
for maintenance or repairs. If you are unsure about the correct
addressing procedure within your network, contact the network
administrator.
• Repeat the above steps for all other bridges.
• Then reset the IP address of the PC to the initial one.
Preparations are now complete, whereupon the following require-
ments for installation on site have been created:
• Creation of measurement location report to document locations
of installation
• Configuration of the bridge for proper integration into the com-
pany network
Proceed with installing the system components in the machine
park. This must be done in the following sequence:
1. Installation of bridge
2. Installation of sensor unit
3. Installation of sensors
Installation and commissioning