Installation and Operation Guide
Table Of Contents
- Chapter 1: Introduction
- 1.1 First steps
- 1.2 Service addresses
- 1.3 About this manual
- Chapter 2: Safety
- 2.1 Safety symbols
- 2.2 Information for the system operator
- 2.3 Information for operating personnel
- 2.4 Intended use
- 2.5 Residual risks and safety measures
- Declaration of conformity
- Certifications
- Chapter 3: Technical data
- Chapter 4: System description
- 4.1 VIBCONNECT RF bridge
- 4.2 VIBCONNECT RF sensor unit
- 4.3 VIBCONNECT RF sensor
- Chapter 5: Installation & commissioning
- 5.1 Quick guide
- 5.2 Configuration in OMNITREND
- 5.3 Installation & commissioning of bridge
- 5.4 Installation & commissioning of sensor unit
- 5.5 Installation of sensors
- 5.6 Configuration in OMNITREND (continued)
- 5.7 Installing additional sensor unit
- Chapter 6: Maintenance
- 6.1 Cleaning
- 6.2 System time correction
- 6.3 Installation report
- 6.4 Battery-powered sensor unit
- 6.5 Update
- 6.6 Warranty
- 6.7 Spare parts and accessories
- Chapter 7: Troubleshooting
- Chapter 8: After use
43
VIBCONNECT RF 05.2012
• After completion of the field strength measurement, remove the
short-circuit bridges and the voltmeter.
• If you do not intend to commission the sensor unit at that point
in time, remove one of the batteries to save energy.
Note
Maintaining battery charge
Until the sensor unit has received a valid measuring configuration
from the bridge, it continuously sends out requests, using battery
power.
» If you wish to program the measuring configuration at a later
stage, switch off battery-powered sensor units by removing
one battery.
Note
IC (Industry Canada)
Under Industry Canada regulations, the sensor unit may only
operate using an antenna of a type and maximum (or lesser)
gain approved for the sensor unit by Industry Canada. To reduce
potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radi-
ated power (e.i.r.p.) is not more than that necessary for successful
communication.
Installation and commissioning