Installation and Operation Guide

3
VIBCONNECT RF 05.2012
Chapter 1: Introduction ..................................................... 5
1.1 First steps ........................................................................ 5
1.2 Service addresses ............................................................ 5
1.3 About this manual .......................................................... 6
Chapter 2: Safety ............................................................... 7
2.1 Safety symbols ................................................................ 7
2.2 Information for the system operator ................................ 7
2.3 Information for operating personnel ............................... 8
Qualification ................................................................................... 8
Personal protective equipment ........................................................ 8
Rules for normal operation ............................................................. 8
2.4 Intended use ................................................................... 9
2.5 Residual risks and safety measures ................................ 10
Declaration of conformity ................................................... 12
Certifications ...................................................................... 13
Chapter 3: Technical data ................................................ 17
Chapter 4: System description ........................................ 21
4.1 VIBCONNECT RF bridge ................................................ 21
4.2 VIBCONNECT RF sensor unit ......................................... 23
4.2.1 Power options ..................................................................... 23
4.2.2 Operating cycle: measuring, sending, idling ......................... 24
4.2.4 Topology of radio cell ........................................................... 26
4.3 VIBCONNECT RF sensor ............................................... 27
Chapter 5: Installation & commissioning ....................... 28
5.1 Quick guide .................................................................. 28
5.2 Configuration in OMNITREND ....................................... 29
5.2.1 Installing and registering device drivers ................................ 29
5.2.2 Setting up the database ....................................................... 30
5.2.3 Creating and printing measurement location report ............. 31
5.3 Installation & commissioning of bridge .......................... 32
5.3.1 Changing IP address of bridge ............................................. 32
5.3.2 Installation preparations ....................................................... 34
5.3.3 Mounting bridge ................................................................. 35
5.3.4 Connecting bridge ............................................................... 36
5.3.5 Commissioning bridge ......................................................... 38
5.3.6 Overview of connections and interfaces ............................... 38
Contents
Contents