Installation and Operation Guide

60
VIBCONNECT RF 05.2012
5.6.4 Creating measuring configuration
This chapter explains how to create a measuring configuration for
a measurement location in the VIBCONNECT RF system, using the
OMNITREND software. A measuring configuration contains infor-
mation regarding
• the measuring tasks
• the time intervals at which measurements are to be performed
• the measurement location assigned to a sensor unit
• the associated bridge.
Measuring tasks
• Select a measurement location.
Note
Always observe the channel assignment:
Channels 1 and 2 are reserved for vibration measurements;
channels 3 and 4 are reserved for temperature measurements
(see also '5.4.4 Connecting sensor unit', page 45).
• In the main menu, select <Machinery Manager> / <Add> /
<Measuring Task>.
• In the measuring task dialog, activate option <Select Setup
Directly>.
• Select the applicable measuring task and click the <Next> button.
• In the next window, click the <Create> button.
• If you wish to set up another vibration measuring task, repeat
the above steps (max. 4 tasks per measurement location).
• For the calculation of the characteristic vibration values, define
the respective band analysis in the alarm wizard.
Installation and commissioning
The characteristic values
are calculated from
a spectrum by means
of “band analyses”