Installation and Operation Guide
Table Of Contents
- Chapter 1: Introduction
- 1.1 First steps
- 1.2 Service addresses
- 1.3 About this manual
- Chapter 2: Safety
- 2.1 Safety symbols
- 2.2 Information for the system operator
- 2.3 Information for operating personnel
- 2.4 Intended use
- 2.5 Residual risks and safety measures
- Declaration of conformity
- Certifications
- Chapter 3: Technical data
- Chapter 4: System description
- 4.1 VIBCONNECT RF bridge
- 4.2 VIBCONNECT RF sensor unit
- 4.3 VIBCONNECT RF sensor
- Chapter 5: Installation & commissioning
- 5.1 Quick guide
- 5.2 Configuration in OMNITREND
- 5.3 Installation & commissioning of bridge
- 5.4 Installation & commissioning of sensor unit
- 5.5 Installation of sensors
- 5.6 Configuration in OMNITREND (continued)
- 5.7 Installing additional sensor unit
- Chapter 6: Maintenance
- 6.1 Cleaning
- 6.2 System time correction
- 6.3 Installation report
- 6.4 Battery-powered sensor unit
- 6.5 Update
- 6.6 Warranty
- 6.7 Spare parts and accessories
- Chapter 7: Troubleshooting
- Chapter 8: After use
62
VIBCONNECT RF 05.2012
Installation and commissioning
5.6.5 Loading measuring configurations to the bridge
• In the main menu, click (Download).
• The data transfer starts automatically. If there are several bridges
registered in OMNITREND, they are invoked in sequence.
Notes
To exclude a bridge from transmission, disable the 'Route and data
import' option in the configuration window (see also '5.6.1 Regis-
tering bridge in OMNITREND', page 54).
The measuring configuration is only forwarded by the bridge to
the sensor unit after it has “woken up” from its idle phase. To force
instant transmission, switch the sensor unit off and on again.
5.6.6 Importing measurement data in OMNITREND
Note
The measurement import must be started manually in the
OMNITREND software. Alternatively, the import can also be au-
tomated through a Windows task. For details, see the Technical
Release # 21, available for free on the PRÜFTECHNIK homepage.
Ensure that the data is regularly written to OMNITREND. Other-
wise, the memory capacity of the bridge might be exceeded so
the oldest measurements are automatically overwritten with the
latest ones.
• In the main menu, click
(Upload).
The data import starts automatically. If there are several bridges
registered in OMNITREND, they are accessed in sequence (see
above).