Installation and Operation Guide
Table Of Contents
- Chapter 1: Introduction
- 1.1 First steps
- 1.2 Service addresses
- 1.3 About this manual
- Chapter 2: Safety
- 2.1 Safety symbols
- 2.2 Information for the system operator
- 2.3 Information for operating personnel
- 2.4 Intended use
- 2.5 Residual risks and safety measures
- Declaration of conformity
- Certifications
- Chapter 3: Technical data
- Chapter 4: System description
- 4.1 VIBCONNECT RF bridge
- 4.2 VIBCONNECT RF sensor unit
- 4.3 VIBCONNECT RF sensor
- Chapter 5: Installation & commissioning
- 5.1 Quick guide
- 5.2 Configuration in OMNITREND
- 5.3 Installation & commissioning of bridge
- 5.4 Installation & commissioning of sensor unit
- 5.5 Installation of sensors
- 5.6 Configuration in OMNITREND (continued)
- 5.7 Installing additional sensor unit
- Chapter 6: Maintenance
- 6.1 Cleaning
- 6.2 System time correction
- 6.3 Installation report
- 6.4 Battery-powered sensor unit
- 6.5 Update
- 6.6 Warranty
- 6.7 Spare parts and accessories
- Chapter 7: Troubleshooting
- Chapter 8: After use
5
VIBCONNECT RF 05.2012
Introduction
Chapter 1: Introduction
1.1 First steps
Checking delivery
Please check the delivered goods without delay for defects or
missing parts. If your delivery is incomplete or you detect defective
parts, mark the respective components on the freight dockets and
contact the shipping company or local PRÜFTECHNIK sales partner.
Responsibilities
The operator of the machine must ensure that:
• All applicable statutory regulations, including safety, accident
prevention and environmental protection regulations, and the
recognized technical safety rules are strictly adhered to
• All tasks for the proper installation of the system components
are performed
• The system is installed by a qualified specialist technician
• All components and tools required for the installation are avail-
able on site (see also chapter “Installation”)
• Electric power and a data network connection that conforms to
the specifications are available on site
• A potential equalization connection is available on site
1.2 Service addresses
If you have any queries, contact us:
Hotline: +49 89 99616-0
E-mail: info@pruftechnik.com
Fax: +49 89 99616-300
PRÜFTECHNIK Condition Monitoring GmbH
Oskar-Messterstr. 19 – 21,
857373 Ismaning, Germany
Note
When calling our hotline, please have the serial number of the
respective component at hand.