Installation and Operation Guide

6
VIBCONNECT RF 05.2012
Introduction
1.3 About this manual
This manual forms part of the product delivery and must be kept
for the entire service life of the product. It might be necessary to
update this document from time to time. If the product is handed
on to another user, you must also hand over this manual.
Disclaimer
The information and data in this manual are provided for infor-
mation purposes only. Although great care has been taken in the
compilation of this document, PRÜFTECHNIK Condition Monitor-
ing GmbH accepts no liability for the accuracy in terms of error or
omission.
PRÜFTECHNIK Condition Monitoring GmbH shall not be liable for
direct or indirect damage resulting from errors, omissions or inac-
curacies in this document.
PRÜFTECHNIK Condition Monitoring GmbH accepts no liability for
damage arising from non-compliance with the instructions in this
manual.
Document structure
This manual contains important information for the proper instal-
lation, commissioning, troubleshooting maintenance, dismantling
and disposal of the VIBCONNECT RF system components.
It has been complied in line with the requirements laid down in
DIN EN 62079:2001.
Document layout
The text in this manual is formatted according to its purpose or
function:
Explanatory text: No indent
Instructions, lists: List with • (bulleted)
General notes: Text delimited with lines at the top and bottom,
preceded by signal word Note
Note
For safety symbols and signs, refer to chapter 2 “Safety”.
Definitions
The following short designations are used in this manual:
• VIBCONNECT RF bridge = bridge
• VIBCONNECT RF sensor unit = sensor unit
• VIBCONNECT RF sensor = sensor
• VIBCONNECT RF
Condition Monitoring System = VIBCONNECT RF or system