Instruction Manual

Assembly- Pre-fabricated Chimney Breast

200799_1

Before commencing further with the installation please ensure the 2 X Fire Support Brackets have been attached to the MDF

Framework, these set the minimum depth required for installation- 238mm. As shown on Page 4.

Decide on the installation height of the fire and construct the studwork around the MDF Framework. The studwork

construction in Diagram 2 is for guidance only.

Ensuring the front face of the MDF framework is flush with the studwork, fix in position through the pre-drilled holes in the

MDF Framework. 3 x fixing holes in the top and bottom and 1 x fixing hole in each side.

Diagram 2

MDF

Framework

Fire Support

Brackets

Studwork

Finishing

Plasterboard, skim and decorate the chimney breast, before installing the fire. As shown in Diagram 3.

Note: The fire is installed in a later procedure.

Diagram 3