Owners Manual

4865 Sterling Drive, Boulder, CO 80301 . PH: 1 (800) PSAUDIO . www.psaudio.com

Owner’s Reference Sprout100

Sprout100’s power amplier provides enough wattage

to power just about any loudspeaker pair. However, we

recommend only one pair of loudspeakers be connected

at a time.

Connect red (+) of the right speaker to Sprout100’s red

(+) right speaker output. Connect the black (-) of the right

speaker to Sprout100’s (-) right speaker output directly

below it. Follow the same convention for the left.

NOTE* The amplier is a balanced output design. If you

were to attempt to ground the black output, the unit will

possibly go into protection as soon as music is played.

Protection mode is indicated by a Red LED on the front

panel.

NOTE* The amplier has a DC voltage that is present

between all of the speaker output jacks and the chassis.

DO NOT attempt to connect or disconnect speakers while

the power cable is plugged in. Doing so could damage

your speakers

Sprout100’s headphone jack is a standard 1/4” stereo

output. We’ve included a 3.5mm to ¼” jack headphone

adapter if you are using a pair of headphones that has the

3.5mm tip.

NOTE* If Headphones are plugged into Sprout100’s

headphone jack the audio signal to the speaker output

and subwoofer output will automatically disable.

Speaker

Connections

Headphones

Operating Guide