Operating instructions
Page 3   
October 2010 
202-890-0403 
ceiver audio. Push the lower button to select the desired COM trans-
mitter. 
The PMA8000B MP3-Series has an automatic selector system. Audio 
from the selected transceiver is automatically heard in the headsets 
and speaker (if selected). You can check this function by switching 
from C
OM 1 transmitter to Com 2 transmitter by pressing the COM 2 
transmitter selector pushbutton. Note that the associated Com 2 re-
ceive pushbutton indicator light that is located immediately above the 
Com 2 transmitter pushbutton turns green. This guarantees that the 
pilot will always hear the audio from the transceiver selected for 
transmit. 
The PMA8000B MP3 “remembers” the receiver selection, so that 
when switching transmitters from C
OM 1 to COM 2, if COM 2 audio 
was previously selected, C
OM 1 audio will continue to be heard. This 
eliminates the pilot having to switch Com 1 audio back on, after 
changing transmitters. 
When switching from C
OM 1 to COM 2 while Com 2 was not previ-
ously selected, C
OM 1 audio will be switched off. In essence, switch-
ing the mic selector will not override prior selection of COM receiver 
audio. 
In normal (not split) modes, the PMA8000B MP3 gives priority to the 
pilot’s radio Push-To-Talk (PTT). If the copilot is transmitting, and 
the pilot presses his PTT, the pilot’s microphone will be heard over 
the selected com transmitter. 
In TEL mode, the pilot microphone and headphones are connected to 
the cell phone. The pilot PTT will switch the pilot mic to the selected 
com transceiver, and allow continued aircraft communications to con-
tinue. (See Page 4—TEL—for more details) 
The copilot will also be able to transmit on the other selected radio 
with his PTT as well. 
Split Mode (Pilot and copilot on different radios) 
The split mode is activated by pressing 
the C
OM 1 and COM 2 XMT buttons at 
the same time. This places the pilot on 
C
OM 1 and the copilot on COM 2. 
Pilot on C
OM 2 and Copilot on COM 1 is 
not possible. 
When the split mode is activated, the 










