Owner's Manual

Remote Sensor Control Dial
Status Light
Status Light: Displays different colours to show: - which source is playing
- a listening mode is chosen
- maximum and minimum volume, bass and treble controls
- Bluetooth pairing mode
Control Dial: Turn: to adjust the volume
Press: to change the input
Remote Sensor: Point the remote control at the remote sensor and press the buttons. Do not expose the remote sensor of the speaker
to light source such as direct sunlight or illumination. If you do so, you may not be able to operate the speaker with the
remote control.
Changing the Brightness of the Status Light
The status light has 3 levels of brightness. High/Low/Off. The speakers will arrive with the brightness level set at High.
I. To change the brightness, hold the SUB button on the remote control for 5 seconds. The brightness level will change to Low.
II. When the brightness level is set to Low, hold the SUB button on the remote control for 5 seconds; the status light will slowly turn Off.
III. Repeat the process and the status light will be set at High again.
Note: When the status light is set to Off, the following will occur:
When turning on the speakers, the brightness will be on High for 3 seconds then slowly turn Off.
To change any function, press any button to activate the status light, then change the function.
After the change has occurred, the status light will return to Off.
Front of the Amplified Speaker