user manual

6-190 0DJHOODQ 6FDQQHU

&RGH/HQJWK&RQWURO

This feature specifies whether variable-length or fixed-length decoding

will be set for Code 39.

To set this feature:

1. Scan the SWITCH bar code.

2. Scan your selection from the bar codes below. You’ll need to cover

any unused bar codes on this and the facing page to ensure that

the scanner reads only the bar code you intend to scan.

3. Complete the programming sequence by scanning the SWITCH

bar code.

CODE 39 LENGTH CONTROL = VARIABLE-LENGTH

CODE 39 LENGTH CONTROL = FIXED-LENGTH

NOTE

If variable-length control was selected, you must now set the features

Code 39 Maximum Label Length and Code 39 Minimum Label

Length. If fixed-length control was selected, you must now set Code

39 Fixed Length 1 and Code 39 Fixed Length 2.