Specifications

Configuring the Falcon

2-4

Falcon

4400 Series with Windows

Date and Time

In this control panel, you can change the year, month, date, time, time zone,

or select automatic adjust for Daylight Savings Time. To set or change the date

and time:

1. Select

Start > Settings > Control

Panel > Date/Time

2. Select the month to open a pull-

down list of months or tap the

arrow buttons on either side of

the month to increase or decrease

the month.

3. To change the year, select the year

to open a numeric dial. Select the

up arrow to increase the value;

select the down arrow to decrease

the value. Or you can type a new

year value in the field.

4. To change the time, select the hour, minute, seconds, or AM/PM and

select the up arrow to increase the value; select/tap the down arrow to

decrease the value. Or you can type a new time value in the field.

5. Select your correct time zone from the pull-down list.

6. To automatically adjust the clock for Daylight Savings Time, enable

the checkbox at the bottom of the screen.

7. Select

Apply to save your changes and make additional modifications.

• Select

OK to save your changes and exit Date/Time Properties.

• Select/tap the close button to exit without saving your changes.

Decoding

You can configure the Falcon’s decoding options by tapping on Start > Settings

> Control Panel > Decoding

. Decoder configuration can also be accomplished for

large numbers of terminals using

FMU (Falcon Management Utility).

There are two sections in the

Decoding control panel, each containing addi-

tional pages. There are six General Configuration pages and multiple Bar

Code symbology pages.