Specifications

Installing the Handle or Handstrap
Product Reference Guide A-9
4. Connect the handstrap hook onto one of the strap studs at the base of
the Falcon.
5. The process is complete upon successful test of the scanning function.
Installing a Handle on the Falcon 4410
To install the handle on the Falcon 4410, complete the following steps:
1. Remove the handstrap as shown in Figure A-10 by removing the
screws located just above the battery cover’s latch dials.
Figure A-11. Removing/Replacing the Handle
2. Insert the top tab of the handle into the slot at the top of the handle
recess (refer to Figure A-11).
Handle
PDT