Specifications

7-160 Magellan
TM
8500Xt Scanner
EAN-13 128 Supplemental Label ID
This feature specifies an EAN-13 128 Supplemental label ID to be added
to barcode data.
NOTE
The programming feature, RS-232 Label ID Control, designates
whether the Label ID is transmitted as a prefix or suffix or if Label ID is
dis-
abled.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan the barcode, SET EAN-13 128 SUPPLEMENTAL LABEL
ID = DISABLE below. You’ll need to cover any unused barcodes
on this and the facing page to ensure the scanner reads only the
barcod
e you intend to scan.
3. Scan the appropriate digits from the keypad in
Appendix C that
represent the desired Label ID characters; entered as two hex
pairs. A table
containing the ASCII Character Set and their corre-
sponding Hex Values is available in the inside back cover of this
manual. ASCII parameters must be input b
y scanning a pair of
hexadecimal digits for each character. Thus, to set a two-character
value of AB, barcodes containing the digits ‘4’, ‘1’, ‘4’, and ‘2’
must be scanned. The selectable range for this option is any hex
value from 00 to FF.
4. Complete the programming seque
nce by scanning the SWITCH
barcode.
SET EAN-13 128 SUPPLEMENTAL LABEL ID = DISABLE