User's Manual

UANPA10 V5.1 PSI Audio User Manual 12
7.2 Poor audio quality
Check the audio cabling to the speaker from the audio source and power cable, for poor wiring or
broken connections.
Problems can occur with incorrect cabling and especially when converting unbalanced signal to
balanced signal. Please refer to chapter 5.3 for details.
7.3 Uneven frequency response
In the case of uneven frequency response, please check the performance of the loudspeaker with a
known reference source (i.e. your favourite CD).
Loss of low frequencies
• Wrong phase or wiring
• Incorrect “Roll Off” calibration
• Wrong positioning in the room.
If performance still does not meet your expectations, please read the section about installation and
calibration of your loudspeaker system to the acoustic environment.
8 C.E. & RoHS Conformities
PSI Audio products have been tested and calibrated according to the highest quality standards.
An individual frequency response diagram is provided with each loudspeaker.
The PSI Audio products have been tested according to EU directives and amendments:
Low voltage directive (LVD), 2006/95/EC
Electromagnetic compatibility directive (EMC), 2004/108/EC
The relevant technical standards are:
EN 60065: 1998 Audio, video and similar apparatus – Safety requirements (Class 1)
EN 55103-1/E1: 1996 Product Standard – Emission
Audio, Video and audio-visual apparatus for professional use
EN 55103-2/E1: 1996 Product Standard – Immunity
Audio, Video and audio-visual apparatus for professional use
This product is manufactured according to the European directive 2002/95/EC
9 Warranty
Our loudspeakers undergo several steps of quality control to ensure they leave our factory in perfect
condition. We offer a warranty against any manufacturing or material defect for a period of 5 years on all
electronics and transducers and 2 years on the wooden cabinets. Only Relec SA is able to qualify a
manufacturing or material defect and its eligibility to be covered by the warranty. Wear and tear are not
covered by the warranty.
Please contact your reseller for any query about warranty or servicing.
We kindly remind the user that unauthorised servicing can void the warranty. In order to provide a quality
service, we ask the user to always include the warranty card at each service.
If goods need to be returned to the manufacturer (Relec SA), the symptoms must be clearly mentioned. In
case of warranty, the parts and labour costs are at the charge of the manufacturer. If no defect in
workmanship is detected, the warranty is considered invalid. A quote for the repair will be sent and the
relative cost charged to the customer.
For services (covered or not by warranty), the expenses and the risks of the transports both ways
between the customer and his supplier are the responsibility and at the charge of the customer.
For any other provision, the Swiss code of obligations, Articles 197 to 210 will apply.
For any legal action, reference will apply to the Court of Yverdon (Switzerland) only.