User's Manual

UANPA10 V5.1 PSI Audio User Manual 5
Power ON LED (Green)
Mains power is present and the speaker is ready
to use.
Voltage Selector / Mains Fuse
Selects AC voltage and fuse value
CAU TION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
GEFAHR : ELEKTRISCHER SCH LAG
NICHT ÖFFNEN
LEVEL ROLL OFF
POWER
INPUT
Model : PSI Audio XX-M
Serial : N° XXXXXXXX
3.2 Front Panel Description
3.3 Rear Panel Description
Limiter or Overheat
or Standby LED (Red)
Flashing of the led indicates that the internal
limiter is working.
If the LED works continuously, the amplifier is
operating under overheated conditions and turns
into standby mode.
Audio Signal Input Connector
Female XLR with the following wiring convention :
1 = Chassis (Ground)
2 = + Hot
3 =
-
Cold
Roll
-
Off Potentiomet
er
Aligns the low frequency response to room
conditions.
Level / Input Sensitivity Potentiometer
Audio input signal calibration
Power On / Off Switch
Anti-slippage stickers to be placed
underneath the unit.