User manual

UANPA10 V4.0 PSI Audio User Manual 12
7.2 Unbalanced to balanced operation
It can give rise to problems and special care should be taken in cabling.
7.3 Poor audio quality
Check the audio cabling to the speaker from the audio source, for poor wiring or broken connections.
7.4 Uneven frequency response
In the case of uneven frequency response, please check the performance of the loudspeaker with a
known reference source (i.e. your favourite CD).
Loss of low frequencies
• Wrong phase or wiring
• Incorrect “Roll Off” calibration
• Wrong positioning in the room.
If performance still does not meet your expectations, please read the section about installation and
calibration of your loudspeaker system to the acoustic environment.
8 C.E. & RoHS Conformities
PSI Audio products have been tested and calibrated according to the highest quality standards.
An individual frequency response diagram is provided with each loudspeaker.
The PSI Audio products have been tested according to EU directives and amendments:
Low voltage directive (LVD), 2006/95/EC
Electromagnetic compatibility directive (EMC), 2004/108/EC
The relevant technical standards are:
EN 60065: 1998 Audio, video and similar apparatus – Safety requirements (Class 1)
EN 55103-1/E1: 1996 Product Standard – Emission
Audio, Video and audio-visual apparatus for professional use
EN 55103-2/E1: 1996 Product Standard – Immunity
Audio, Video and audio-visual apparatus for professional use
This product is manufactured according to the European directive 2002/95/EC
9 Warranty
Our products are guaranteed for 2 years against any manufacturing defects. Fair or wrong wear and tear
are not covered by the warranty. We kindly remind the user that unauthorised servicing can void the
warranty. In order to provide a quality service, we ask the user to always join the warranty card for each
servicing.
If our goods are sent back to the manufacturer, the symptoms must be clearly mentioned. In case of
warranty, the parts and labour costs are at the charge of the manufacturer. If no defect in workmanship is
detected, the warranty is therefore not valid. A repair quotation will be sent and the relative lump cost will
be charged to the customer.
For services (covered or not by warranty), the expenses and the risks of the transports both ways
between the customer and his supplier are the responsibility and at the charge of the customer.
For any other provision, the Swiss code of obligations, Articles 197 to 210 will apply.
For any legal action, reference will apply to the Court of Yverdon (Switzerland) only.