User`s manual

50
Section 3
V680 Commands
RFID System
User's Manual
Section 3
Commands
Button Auto (BA) Communications Specifications
A button auto (BA) communication specification is used to execute auto commands after the command
is sent from the host device and the activate switch of the Hand-held Reader Writer is pressed.
1. Send the command from the host device to the Hand-held Reader Writer. The operation indicator will
light green.
2. Press the Hand-held Reader Writer activate switch.
3. The Hand-held Reader Writer will enter the communication stand-by state with the ID Tag, and the
operation indicator (LED) will flash green.
If the ID Tag is not detected within one minute of sending the command, a timeout will occur and an ID Tag Non-existent
Error will occur. As a result, the operation indicator will flash red.
4. Communications with the ID Tag will be performed when the antenna end of the Hand-held Reader
Writer is moved close to an ID Tag.
5. A response is returned from the Hand-held Reader Writer to the host device.
If communications end normally, the operation indicator (LED) will light green and then turn OFF.
D
A
E
Communications
with ID Tag
Response
Command
B
Press
Hand-held Reader Writer
Hos
t device
ID T
ag
B