User`s manual

70
Section 3
V600 Commands
RFID System
User's Manual
Section 3
Commands
V600 Commands
There are 4 types of commands for communicating with the ID Tag using the Hand-held Reader Writer.
• Normal commands
• Button commands
• Auto commands
• Button auto commands
Normal Commands
Normal commands are sent from the host device for communications with the ID Tag, after the antenna
end of the Hand-held Reader Writer has been moved close to the ID Tag.
1. Move the antenna end of the Hand-held Reader Writer close to the ID Tag.
2. Commands are sent from the host device to the Hand-held Reader Writer.
3. The Hand-held Reader Writer communicates with the ID Tag.
4. A response is returned from the Hand-held Reader Writer to the host device.
If communications end normally, the operation indicator (LED) will light green and then turn OFF.
If the ID Tag is not detected within the Hand-held Reader Writer's communication area when the com-
mand is sent from the host device, an ID Tag Non-existent Error will occur.
At this time, the operation indicator will flash red.
A
C
B
D
Communications
with ID Tag
Response
Command
Host device
Hand-held Reader Writer
ID Tag