User`s manual

72
Section 3
V600 Commands
RFID System
User's Manual
Section 3
Commands
Auto Commands
Auto commands can execute communications with the ID Tag when the antenna end of the Hand-held
Reader Writer has been moved close to the ID Tag after the command is sent from the host device.
1. A command is sent from the host device to the Hand-held Reader Writer.
2. The Hand-held Reader Writer enters the communications stand-by state with the ID Tag, and the
operation indicator (LED) flashes green.
If the ID Tag is not detected within one minute of sending the command, a timeout will occur and an ID Tag Non-existent
Error will occur. As a result, the operation indicator will flash red.
3. Communications with the ID Tag are performed when the antenna end of the Hand-held Reader Writer
is moved close to the ID Tag.
4. A response is returned to the host device from the Hand-held Reader Writer.
If communications end normally, the operation indicator (LED) will light green and then turn OFF.
C
A
D
Communications
with ID Tag
Response
Command
Hos
t device
ID T
ag
Hand-held Reader Writer
B