User`s manual

73
RFID System
User's Manual
Section 3
V600 Commands
Section 3
Commands
Button Auto Commands
Button auto commands execute auto commands after a command is sent from the host device and the
activate switch of the Hand-held Reader Writer is pressed.
1. A command is sent from the host device to the Hand-held Reader Writer. As a result, the operation
indicator will light green.
2. Press the Hand-held Reader Writer activate switch.
3. The Hand-held Reader Writer enters the communications stand-by state with the ID Tag, and the
operation indicator (LED) flashes green.
If the ID Tag is not detected within one minute of sending the command, a timeout will occur and an ID Tag Non-existent
Error will occur. As a result, the operation indicator will flash red.
4. Communications with the ID Tag are performed when the antenna end of the Hand-held Reader Writer
is moved close to the ID Tag.
5. A response is returned to the host device from the Hand-held Reader Writer.
If communications end normally, the operation indicator (LED) will light green and then turn OFF.
D
A
E
Communications
with ID Tag
Response
Command
B
Press
Hand-held Re
ader Writer
Host device ID Tag
B