User`s manual

83
RFID System
User's Manual
Section 3
V600 Commands
Section 3
Commands
■ BUTTON READ (BR)
After this command is received by the Hand-held Reader Writer, data is read from the ID Tag by press-
ing the activate switch. If the activate switch is pressed and the ID Tag is not in the communications
area, an error response (end code: 72 = ID Tag non-existent) will be returned.
Processing Area Number: 1
Processing Area Number: 2
Data setting Sets the code format used to send responses for read data.
A: ASCII
H: Hexadecimal
When multiple processing areas are used, ASCII and hexadecimal can be specified at the same
time within a single command frame.
Processing area number
setting
Specifies the processing area number.
Setting range: 1 to 9, A (A = 10)
Read area start address Specifies the start address of the area in the ID Tag to be read from in 4-digit hexadecimal.
Setting range: 0000 to FFFF hex
When multiple processing areas are used, specify the areas in order starting from the smallest
address. The same area cannot be specified twice.
Number of read bytes Specifies the number of bytes to be read from the ID Tag in 2-digit hexadecimal.
The maximum number of bytes that can be read at one time is 256 bytes.
• ASCII: 256 bytes (256 characters)
• Hexadecimal: 256 bytes (512 characters)
Setting range: 00 to FF hex (00 = 256 bytes)
When multiple processing areas are used, set so that the total number of bytes to be read for all
areas is within 256 bytes, as follows:
Area (1) bytes +...+ Area (N) bytes ≤ 256 bytes
Command
××
BR
××
A/H 1
××
211 4 2
2
CR
Number of
read bytes
Terminator
Command
code
Data
setting
Processing
area
number
setting
Read area
start address
××
BR
××
A/H 2
××
211 4 2
2
CRA/H
1
××
××××
42
Terminator
Number of
read bytes
Command
code
Data
setting
Processing
area number
setting
Read area
start address
Number of
read bytes
Data
setting
Read area
start address
Area (1) setting
Area (2) setting