Developers guide

Psion Teklogix Mobile Devices SDK Developers Guide 99
Chapter 14: Scanners
Configuring Bar Code Symbologies
Code 39 Settings
SDK:
These settings can be changed and queried through the SDK as follows:
Intermec ISCP Imager
These settings apply only to the Intermec ISCP imager acting as a decoded scanner using the Code
39 symbology.
Control Panel:
These settings are changed through the Control Panel Scanner Properties as follows:
SDK:
These settings can be changed and queried through the SDK as follows:
Scanner Setting Key: Barcode\C39\Imager
Scanner Setting Name Minimum Maximum Default Control Panel Name
Enabled 0 = off 1 = on 1 Enabled
Full ASCII 0 = off 1 = on 0 Full ASCII
Check Digit Verification 0 = off 1 = on 0 Check Digit Verification
Include Check 0 = off 1 = on 0 Include Check
•Tab
Barcodes
• Scanner:
Decoded (Intermec ISCP)
• Menu Item
Code 39
Scanner Setting Key: Barcode\C39\ICSP
Scanner Setting Name Minimum Maximum Default Control Panel Name
Enabled 0 = off 1 = on 1 Enabled
Full Ascii Conversion 0 = off 1 = on 0 Full ASCII
Reading Range 0 1 1 Reading Range
Start Stop Transmission 0 = off 1 = on 0 Start/Stop Transmit
Accepted Start Character 1 3 3 Accepted Start Char
Check Digit Verification 0 3 0 Check Digit Verification
Transmit Check Digit 0 = off 1 = on 0 Transmit Check Digit
Length L1 0 255 0 Minimum Length