Developers guide

Chapter 14: Scanners
Configuring Bar Code Symbologies
116 Psion Teklogix Mobile Devices SDK Developers Guide
SDK:
These settings can be changed and queried through the SDK as follows:
HHP Imager
These settings apply only to the HHP imager acting as a decoded scanner using the Codabar
symbology.
Control Panel:
These settings are changed through the Control Panel Scanner Properties as follows:
SDK:
These settings can be changed and queried through the SDK as follows:
14.3.3.11Code 93 Settings
Non-decoded Scanner
These settings apply to an internal or external non-decoded scanner using the Code 93 symbology.
Scanner Setting Key: Barcode\CDB\ICSP
Scanner Setting Name Minimum Maximum Default Control Panel Name
Enabled 0 = off 1 = on 0 Enabled
Start Stop Transmission 0 4 0 Start/Stop Transmit
CLSI Library System 0 = off 1 = on 0 CLSI Library System
Check Digit Verification 0 = off 1 = on 0 Check Digit Verification
Transmit Check Digit 0 = off 1 = on 0 Transmit Check Digit
Length L1 0 255 6 Set Length L1
Length L2 0 255 0 Set Length L2
Length L3 0 255 0 Set Length L3
Length Mode 0 1 0 Length Mode
•Tab
Barcodes
•Scanner:
Decoded (HHP)
• Menu Item
Codabar
Scanner Setting Key: Barcode\CDB\HHP
Scanner Setting Name Minimum Maximum Default Control Panel Name
Enabled 0 = off 1 = on 1 Enabled
Start Stop Char 0 = off 1 = on 0 Start/Stop Transmit
Check Char 0 2 0 Check Char
Concatenation 0 2 0 Concatenation
Length Min 2 60 4 Minimum Length
Length Max 2 60 60 Maximum Length