Developers guide

Chapter 14: Scanners
Configuring Bar Code Symbologies
122 Psion Teklogix Mobile Devices SDK Developers Guide
Control Panel:
These settings are changed through the Control Panel Scanner Properties as follows:
SDK:
These settings can be changed and queried through the SDK as follows:
HHP Imager
These settings apply only to the HHP imager acting as a decoded scanner using the Interleaved 2
of 5 symbology.
Control Panel:
These settings are changed through the Control Panel Scanner Properties as follows:
SDK:
These settings can be changed and queried through the SDK as follows:
•Tab
Barcodes
•Scanner:
Decoded (Intermec ISCP)
• Menu Item
Interleaved 2 of 5
Scanner Setting Key: Barcode\I25\ICSP
Scanner Setting Name Minimum Maximum Default Control Panel Name
Enabled 0 = off 1 = on 0 Enabled
Reading Range 0 1 1 Reading Range
Check Digit Verification 0 2 0 Check Digit Verification
Transmit Check Digit 0 = off 1 = on 0 Transmit Check Digit
Length L1 0 255 6 Set Length L1
Length L2 0 255 0 Set Length L2
Length L3 0 255 0 Set Length L3
Length Mode 0 1 0 Length Mode
•Tab
Barcodes
•Scanner:
Decoded (HHP)
• Menu Item
Interleaved 2 of 5
Scanner Setting Key: Barcode\I25\HHP
Scanner Setting Name Minimum Maximum Default Control Panel Name
Enabled 0 = off 1 = on 0 Enabled
Check Digit 0 1 0 Check Digit
Length Min 2 80 4 Minimum Length
Length Max 2 80 80 Maximum Length